Beyond a Control Cabinet's IP Rating: Which Openings, Seals and Installation Conditions Should Buyers Check?
Match the tested configuration in the report to the actual delivered configuration, item by item.

Buyers should work back from the operating environment to define protection requirements
Buyers should check the complete delivered configuration rather than accept an entire control cabinet based only on the IP marking of its empty enclosure.
The IP code describes the protection an enclosure provides against the ingress of solid foreign objects and water. The Swedish electrical safety authority explains the functions of the two digits, while public IEC materials also describe the relationship between IP codes and protection against water ingress. [Source 1][Source 2] Buyers can use these materials to understand the marking, then ask engineers to select requirements for the actual environment.
Factory dust, outdoor rain and cleaning water are different operating conditions. Procurement teams should specify the installation location, cleaning method and cable entries, then ask suppliers to explain how the proposed delivered structure meets the requirements. Buyers should not use “waterproof” as the only specification.
How buyers can check the sample described in the report
The following are procurement review recommendations. Buyers should ask suppliers for the tested model, enclosure dimensions, door seal design, fasteners and accessory configuration. If the actual delivery adds a display, fan or cable gland, buyers should ask the supplier whether the evidence still covers these changes.
Procurement teams can create a simple checklist for each opening. Engineers should check whether cover plates are installed, whether seals are compatible and whether installation instructions specify how they must be compressed or tightened. Any drilling by the installer on site should also be approved by engineering personnel.
| Location on the delivered unit | Evidence buyers should request | Main points to check on site |
|---|---|---|
| Joint between the door and enclosure | Seal design and assembly requirements | A continuous sealing strip with no obvious damage |
| Cable entries | Gland model and compatible cable diameters | Actual cable diameters match the gland's requirements |
| Unused openings | Blanking accessories and installation requirements | Every opening is correctly sealed |
| Display or ventilation accessories | Protection evidence for the relevant configuration | Accessories match the configuration in the report |
How buyers can arrange arrival and installation acceptance checks
Buyers can separate unpacking checks from post-installation checks. At unpacking, staff record the condition of the enclosure, seals and accessories. After installation, staff record the cable entry arrangements, sealing of unused openings and door lock condition. Both sets of photographs should be linked to the same equipment identifier.
Procurement teams should also agree on replacement part models and maintenance instructions for damaged seals. Buyers cannot claim to have completed a standard test simply by spraying water on the unit casually on site. Any testing should be carried out by competent personnel using the applicable method.
Scope and limitations
An IP rating should not be used as a substitute for evidence of explosion protection, corrosion resistance, impact resistance or electrical safety of the complete equipment. Projects may also be subject to local installation codes and product requirements. Buyers should have their engineering teams check the formal standards, applicable editions and test conditions.
FAQ
Can buyers accept a complete control cabinet supported only by a report for the empty enclosure?
Buyers should confirm that the report or other technical evidence covers the actual assembled configuration, especially openings and accessories added later.
Can buyers add cable entry holes on site themselves?
Buyers should first have the supplier and engineers confirm how the changes affect protection, then carry out the work using the approved method.
How should buyers handle a damaged sealing strip?
Buyers should record the equipment identifier and damage, replace it with a matching component as specified by the supplier, and then complete the installation checks.
Suggested use on stellar.shop
When looking for control cabinet or complete equipment suppliers on stellar.shop, buyers can provide opening drawings, cable specifications and details of the installation environment, and ask suppliers to respond for the complete configuration.